After purchasing new probe tips for my multimeter I tested the power supply at the connector to the solenoid driver.
I am getting power where it is supposed to be but the voltages are not right:
when I check pins 4 and 1,2 ... I get 12v which matches the circuit diagram
pins 4 and 12 give 33vac instead of 24
pins 4 and 13 give 27v instead of 24
pins 4 and 15 give 5v. Matching circuit diagram
So its off to the forums to ask if this is the problem or no big deal and it is within tolerances
No comments:
Post a Comment