Showing posts with label electrical. Show all posts
Showing posts with label electrical. Show all posts

Wednesday, March 21, 2018

Rebuilding a pinball flipper

On the Harlem Globetrotters pinball machine, only two of the three flippers were working and they seemed sluggish. It was time to rebuild them!



Step 1 was to get it off the table. I unscrewed the plate everything was on and tried to remove it. No luck. It was connected to the flipper on the other side. I thought I would just pry the flipper off, no luck.

Finally after some head scratching I noticed the hex pins on the side of the shaft. It took awhile to locate the proper sized hex tool, but eventually I was able to loosen it.




Once it was removed I was able to take the whole unit apart.


Into the tumbler all of the parts went for an overnight cleaning and polishing.The plunger itself was sanded with 1000 grit sandpaper and then polished with some polish so it would slide through the solenoid with ease.

After a night of tumbling and cleaning everything out, it was time to put it all back together. I don't have too many pictures, but I do have a nice little 15 second video of the flipper in action. Check out the action on this thing!

Woohoo, now to do the other two!


Friday, March 16, 2018

minimal progress on the Argosy

I installed the replaced score motor last night. 


And turned it on. There is good news and bad.

The good news is that it runs!

The bad news is that it runs and runs and runs and runs...

From my reading, this is a pretty common problem. Somewhere there is a stuck switch or wheel preventing it from finishing the reset operation.

Now to dig through it all and find it.

Tuesday, March 13, 2018

Argosy Motor Replacement

As you may recall from the last post, the score motor was in sad shape and needed repair or replacement.

I contacted a vendor (Steve Young at pbresource.com ) who makes replacements and ordered one. Steve is a great guy to work with and the motor arrived quickly and worked great.

Unfortunately, as Steve carefully explained, the replacement part has a different set of mounting holes than the original.
old and new score motors

The solution was to drill and tap a new set of holes in the old motor mount. So I ran down the the hardware store with the bolt in hand. A few bucks later I had a tapper and made short work of the hole:
tapping the hole

And the new motor was mounted to the bracket:

I then did a quick test by connecting the motor wires and turning the unit on:



And it worked beautifully. Next step is to put the motor back into the machine and see if it boots up correctly.